RailNet Documentation

RailNet ESM Pro WebUI Manual

A short customer-facing guide for connecting to the ESM Pro WebUI, changing settings, and controlling the device from the browser interface.

Quick Start

  1. Power the unit and wait about 30 seconds.
  2. Connect your phone or PC to the device Wi-Fi access point.
  3. Default SSID: RailNet - ESM Pro
  4. Default password: railnet1
  5. Open a browser and go to http://192.168.4.1.
  6. On the Dashboard, enable Web Override if you want to control the device from the WebUI.

Wi-Fi / Access Point

  • The device runs as a Wi-Fi access point (AP).
  • Default SSID: RailNet - ESM Pro
  • Default password: railnet1
  • To change the AP name or password, go to Settings > Network, save the changes, then reconnect to the new Wi-Fi network.

Dashboard

  • Device Status: Shows connection and run state.
  • Override: Enables web control and web-trigger actions.
  • Trigger Mode: Select Manual or Web if available in your build.
  • Actions: Trigger runs while held. Latch Trigger toggles run on or off.
  • Save Settings: Stores WebUI settings on the device.

Lighting / Audio Controls

  • Mode: Shows the current mode read from the hardware selection.
  • Timing: Adjust flash, sequence, and random dwell values.
  • Dim / Volume: Adjust output level as provided in the UI.
  • Bank / Channel Controls: If enabled in your build, configure per-bank or per-channel behavior.

Sequences

  • Use the Sequence controls, if present, to select or run a sequence.
  • Some builds allow sequence autostart when override is enabled.

Firmware Update

  1. Build or obtain the firmware bundle ZIP.
  2. Use the RailNet updater tool or approved flashing workflow.
  3. Keep power stable during flashing.

Troubleshooting

  • UI not loading: Reconnect to the AP and refresh. Try http://192.168.4.1.
  • Settings not applying: Confirm Web Override is enabled, then select Save Settings.
  • Trigger not responding: Check Trigger Mode and override state.
  • Audio not playing: Verify file selection and volume.
  • Wi-Fi changes not applied: After saving new AP settings, reconnect to the new network.
  • Still stuck: Power-cycle the unit and reconnect.

Notes

  • Hardware switches, if present, can override or set defaults depending on your firmware build.
  • If something looks stuck, power-cycle the unit and reconnect.